| Main > Main Forum |
| Spinner what Axis? |
| (1/1) |
| bent98:
I have a TT2 spinner and a Happ USB 3 inch trackball. Just wondering if I should put it on the x,y, or Z axis? Is there any advantage or disadvantge to putting spinner on Z axis? Also if I did put it on the Z Axis, which controls setting in Mame do I change? |
| fixedpigs:
sometimes backspin will be a problem on the z axis...it was for me and at least one other guy... i put it on the x axis and it was good to go... if you put it on the y axis...then you could use it to scroll through your gamelist on mala... |
| bent98:
No conflict with it sharing same as trackball? |
| Encryptor:
Maybe reading this thread will help you figure out which one to use. http://forum.arcadecontrols.com/index.php?topic=75693.0 Encryptor |
| RandyT:
--- Quote from: bent98 on February 28, 2008, 09:21:17 pm ---No conflict with it sharing same as trackball? --- End quote --- Not if the trackball is on a physically different interface board. But they cannot both be connected to the same board and axis. RandyT |
| Navigation |
| Message Index |