| Main > Main Forum |
| Can this button be installed in 16mm MDF? How? |
| << < (2/2) |
| Minwah:
--- Quote from: Stormrider on February 29, 2008, 04:51:57 am ---What if I use glue to fit them? I'll use 4 of these buttons for coin, start, and service operations. --- End quote --- Trouble is it makes replacing them in the future more of a pain. I would just try it first, as the others said the force on them will be towards the wood so they might just stay in place without glue. |
| severdhed:
i'd say try it in a scrap piece of wood and see how they hold....if they don't use a metal panel. |
| Sammie:
if you are good with a router you can recess the inside of the MDF panel so the MDF panel is the same thickness as the metal the switch is suppose to work with. I am not sure how well the MDF will hold up with downward pressure being that thin. |
| Fozzy The Bear:
--- Quote from: Sammie on February 29, 2008, 05:42:40 pm ---I am not sure how well the MDF will hold up with downward pressure being that thin. --- End quote --- It won't... and that's a really bad idea given that the metal is less than 1/16" thick. Best Regards, Julian (Fozzy The Bear) |
| Navigation |
| Message Index |
| Previous page |