I didn't want to raise the dead with the original topic posting which can be read over here:
http://forum.arcadecontrols.com/index.php?topic=56909.0I have bought a house etc... since that topic was started and had to move all my cabs... blah blah blah, life. Well I am back at it now.
I hooked up the inverter board using the Non-Invert Out to the monitor because the Non-Invert output does not require the inverter board to have a +16V input.
The monitor seemed to be washed in yellow. When I pushed the actual "G" green pot toward the outputs of the inverter the yellow wash went away.
I suspected solder joints so I reflowed the solder on most of the board. Now that I have hooked the board back up all I get is the yellow wash on the screen.
I have tried adjusting the flyback, the brightness, the inverter pots, the neckboard pots. Everything. Any one have any experience on troubleshooting inverter boards?
EDIT: Without the inverter installed the game DOES play correctly. It is a DK3 board with a Sanyo 20ez monitor.