| Main > Main Forum |
| First Time Confusion - help! |
| << < (3/5) > >> |
| shardian:
--- Quote from: RetroACTIVE on February 11, 2008, 01:42:09 pm ---I prefer not to use QDs on the old leaf switches... the tabs are very flimsy and sometimes getting the QDs on and off is risky... for those I tend to solder. --- End quote --- Most definitely! I broke off a leaf terminal on one of the Wico 8-ways in my Dynamo cabinet. I had to replace it with a leaf off one of those chinese knockoff 4-ways. ;D |
| RetroACTIVE:
--- Quote from: shardian on February 11, 2008, 01:45:54 pm ---Most definitely! I broke off a leaf terminal on one of the Wico 8-ways in my Dynamo cabinet. I had to replace it with a leaf off one of those chinese knockoff 4-ways. ;D --- End quote --- Not to mention they are like little tiny freak'n razor blades! |
| mountain:
When I build my next cab, I plan on soldering a 2" extention wire on Wico leafswitches with a QD spade on the end. I am planning on building a new machine right now and I would love to plug in some other joysticks to test them out but it would require yanking the Wicos (de-soldering). |
| ChadTower:
--- Quote from: mountain on February 11, 2008, 02:09:32 pm ---When I build my next cab, I plan on soldering a 2" extention wire on Wico leafswitches with a QD spade on the end. I am planning on building a new machine right now and I would love to plug in some other joysticks to test them out but it would require yanking the Wicos (de-soldering). --- End quote --- Don't do that. Wire them into a Molex connector if you plan on swapping them later. That makes it a two second no brain swap rather than having to keep track of what wire is going where and swapping all of those individual QDs. |
| mountain:
The way I tie my wiring, it will be obvious. Good point though. |
| Navigation |
| Message Index |
| Next page |
| Previous page |