| Main > Main Forum |
| Shortest Buttons? |
| << < (2/2) |
| Bender:
http://www.coinopexpress.com/products/parts/push_button/33mm_Round_Momentary_Contact_Push_Button_with_Clipper_2295.html I found these but they have a minimum order of 960 :banghead: I only need like 4 or 6 these would work especially if I bent the contacts down they may only be 13mm deep I'll keep lookin' I still think there may be a way to make some too |
| protokatie:
--- Quote ---I still think there may be a way to make some too --- End quote --- Take a happ button, remove the spring, and cut it down to near the ring. Super glue in a leaf spring and jerry rig a happs style switch in there... Most of a Happs (or similar) button is shaft and spring... If you are willing to sacrafice a button, im sure you will find a way to make them really short. There is a limit tho, you need some level of decernable travel for the button... |
| Kajoq:
Bender - go check out http://www.lizardlick.com They have a great selection of Sanwa and Seimitsu parts, and ship super fast. I've ordered a ton of parts from them. The sanwa buttons aren't going to be as thin as that button you linked because they have external microswitches (that are a lot nicer than the ones on that button) I can't find a tape/ruler anywhere handy, but the sanwa screw-in i have in front of me is probably just a touch over 1" tall, going from top to bottom of the terminals. If i'm understanding your clearance issue correctly, I think you could make the sanwas work if you got screw ins. Route out a hole a little larger than the button and mount it inside the hole |
| Orclord:
These are some available in the UK... http://www.gremlinsolutions.co.uk/ordersanwapushbuttons.php... Might give you a few model numbers to google for US sources... |
| divemaster127:
I can get these for you from happ & there is no min. order dm http://happcontrols.com/pushbuttons/601200xx.htm |
| Navigation |
| Message Index |
| Previous page |