Main > Main Forum
what is the best way to make your project come out looking polished
<< < (2/4) > >>
csa3d:

--- Quote from: Kangum on February 03, 2008, 11:38:29 am ---ive modeled a project in sketchup and even built it out of foam fiber board. what are some other things i can do to make this project come out just as i designed it.

im afraid if i just start building it will come out half a---d. any tips?

--- End quote ---

Invest in the right tools.  When searching the forums, people suggest you should use certain tools.  Most of the time, they are right.  I think if you have the right equipment, you are going to be more successful.

Don't be afraid to ask questions, and to just dive in.  I had a lot of my project planned in autocad (Maya) and found out that during install, other modifications where required.  Some where on the fly, others were back to the drawing board.  By the time you're done your project, you'll have that feeling that your next project will be much easier. 

Do plan ahead, but be warned about over-planning.  At some point in time, you can't plan everything and problems will arise.

My 2 cents!  Good luck, warrior!
-csa
pcb:

--- Quote from: Kangum on February 03, 2008, 03:54:53 pm ---the cuts are all straight so the most difficult part i think for me will be the t-slot cutting. ive never used a router and im a little nervous i will chop it to shreds.

--- End quote ---

Make practice cuts on scrap from you project first.  Then see how the t-molding fits, adjust, cut more scrap, etc.  It is not difficult to do, but does take a bit of practice.

Best,

 - Mike -
Teknique:

--- Quote from: csa3d on February 03, 2008, 04:15:39 pm ---
--- Quote from: Kangum on February 03, 2008, 11:38:29 am ---ive modeled a project in sketchup and even built it out of foam fiber board. what are some other things i can do to make this project come out just as i designed it.

im afraid if i just start building it will come out half a---d. any tips?

--- End quote ---

Invest in the right tools.  When searching the forums, people suggest you should use certain tools.  Most of the time, they are right.  I think if you have the right equipment, you are going to be more successful.

Don't be afraid to ask questions, and to just dive in.  I had a lot of my project planned in autocad (Maya) and found out that during install, other modifications where required.  Some where on the fly, others were back to the drawing board.  By the time you're done your project, you'll have that feeling that your next project will be much easier. 

Do plan ahead, but be warned about over-planning.  At some point in time, you can't plan everything and problems will arise.

My 2 cents!  Good luck, warrior!
-csa

--- End quote ---

Agreed.  I have lived by the motto that any successful project is 80% the right tools and 20% knowledge.  The 'right' tools in this case though do no have to be the most expensive, just the correct ones for the application intended.  This means using a router over a dremel or using a table saw over a circular saw, etc.   

Take your time- measure once, set the tool up and then remeasure.

Tek
leapinlew:
take your time...

fatfingers:


There are really only 2 rules to follow to succeed:


* Don't let me work on it
* Actually complete the project
Navigation
Message Index
Next page
Previous page

Go to full version