| Main > Main Forum |
| Best way to attach cable/wires to MDF |
| << < (5/5) |
| protokatie:
For my first cab (still in planning stages) I shall be using the might and power of the venerable Duct Tape! (*sighs* yes I am that pathetic about it ;) ) Then again, I plan on tinkering with my first cab alot to get it "just right", so for me duct tape would be a good idea. Once I get stuff to where I want it, I plan on using those plastic coated staples meant for mounting wiring. |
| DeLuSioNal29:
--- Quote from: Avrus on February 01, 2008, 06:58:52 pm ---If you check my project thread or webpage, I use plastic clips that screw into the wood. They do a great job of cable organization. --- End quote --- I did the same. Plastic wire clips at Radio Shack and small wood screws to hold them in. Worked out great! ~ DeLuSioNaL |
| pcb:
--- Quote from: Steven633 on February 01, 2008, 01:16:06 pm ---OK guys, I am looking to start wiring up the mean machine (my CP) this weekend and am looking for any magic tips on how to keep the wiring nice and tidy. --- End quote --- Another good solution are "anchor ties". They serve two purposes, as a cable tie and they have a screw hole. http://www.mikesarcade.com/cgi-bin/store.pl?sku=CABLETIE7IN You can get them by the bag at Home Depot. |
| Navigation |
| Message Index |
| Previous page |