| Main > Main Forum |
| Best way to attach cable/wires to MDF |
| << < (4/5) > >> |
| Fozzy The Bear:
There is of course an easier way than these fall off sticky backs....... Just use an ordinary nail on cable clip... Then pass a cable tie through the loop of it. Best Regards, Julian (Fozzy The Bear) |
| Brax:
I prefer plastic p-clips. Mechanical fasteners are the way to go. |
| MaximRecoil:
Probably the simplest, easiest, and cheapest method is to put a staple where you want to attach the wire(s) to the wood (leave a little bit of the staple sticking up) and that gives you a point to attach the wires to the staple with a wire tie. That's how it was done from the factory in my Dynamo cabinets. |
| FhM:
While looking for the mounts I was thinking of I noticed a lot of the sticky ones had screw holes to but they dont look of particularly good quality. I did find these from here though that look good: |
| Avrus:
--- Quote from: Brax on February 02, 2008, 10:38:11 am ---I prefer plastic p-clips. Mechanical fasteners are the way to go. --- End quote --- Yup that's what I'm using and they work really well. |
| Navigation |
| Message Index |
| Next page |
| Previous page |