Main > Retail vendors
Sale!! Controller Hacks - Xbox 360, Dreamcast, Xbox, PS2, etc!
taternutz:
PM Sent
escher:
PM and payment sent. Now I just need to wait for LL to get more Sanwa stuff in stock. :(
escher:
Woohoo! Just got mine today, and it's almost perfect.
The right trigger wires weren't glued down, and one of the solder points snapped in shipping. Not a huge deal; I'm pretty noobish with a soldering iron, and I fixed it in a couple seconds. Actually, now that I look at it, I don't think HarumaN glues down the trigger connections because of where they are on the board. I might wrap mine in some hot glue to add a little more structure, since I imagine the box'll get a little beat up over time. I might try to pull a 3.3v line out later on for an LED, too.
ANYHOW.
I highly recommend this service. HarumaN was great throughout the whole thing, answering a slew of at least semi-annoying questions through PMs. I might have been able to get it wired up on my own, but there's no way in hell I could have got it as clean and solid.
* escher sits and waits not-so-patiently for his akihabarashop order to come through.
Once again, to reiterate through my little ramble, this was totally worthwhile. I would have killed at least two pads trying to do this on my own.
HaRuMaN:
Hmm, did I not glue the trigger wires? I must have overlooked that, I normally do. My bad... :dizzy:
escher:
--- Quote from: HarumaN on April 16, 2009, 10:51:33 pm ---Hmm, did I not glue the trigger wires? I must have overlooked that, I normally do. My bad... :dizzy:
--- End quote ---
No problem. I figured it was because they're in a rough place to lay flat on the board. I'll just add some around the connections (leaving them standing vertical) before I throw it in the actual box.
It was fun testing the thing out with just a small U of wire. :)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version