| Main > Main Forum |
| Konami GT Wiring question |
| (1/2) > >> |
| milhouse:
I just received a Konami GT control panel that has the optical encoder still attached. I am planning on using it in a MAME cab but I can't tell what the connections are for the Encoder Board (they don't appear to be labeled). Anyone have any thoughts? Thanks |
| Fozzy The Bear:
--- Quote from: milhouse on February 01, 2008, 12:29:20 am ---I just received a Konami GT control panel that has the optical encoder still attached. I am planning on using it in a MAME cab but I can't tell what the connections are for the Encoder Board (they don't appear to be labeled). --- End quote --- I don't have the circuit diagram to hand right now.... but can't you just trace the tracks on circuit board to see what they are and where they go to??? Best Regards, Julian (Fozzy The Bear) |
| milhouse:
I tried but can't tell. ' Here is a (bad) photo in case that helps anyone. Thanks |
| Fozzy The Bear:
--- Quote from: milhouse on February 01, 2008, 07:57:32 am ---I tried but can't tell. ' Here is a (bad) photo in case that helps anyone. Thanks --- End quote --- I can't trace them from that photo, try removing that paper sticker so you can see where the tracks are. The only one I can see.... It looks like the ground is the one at the top of the connector. Best Regards, Julian (Fozzy The Bear) |
| CheffoJeffo:
This took me a while to find ... my search-fu powers are weakening: http://www.arcadeuk.com/pinouts/KonamiGT.htm |
| Navigation |
| Message Index |
| Next page |