| Main > Main Forum |
| ran into a problem need some input |
| << < (5/7) > >> |
| clickhea:
i see what your saying so the only fix for that would be to cut the cabinet down a bit? |
| Havok:
--- Quote from: clickhea on January 26, 2008, 12:12:35 am ---i see what your saying so the only fix for that would be to cut the cabinet down a bit? --- End quote --- Just don't mount any controls near the edge of the control panel. Remember - your cabinet is hollow, all kinds of stuff should fit inside... 8) |
| clickhea:
alright well heres a question normally how tall are the control box sides? 2 inches? 3 inches? how much clearance are required for the parts once they are installed? i'll see if i can go by this to make my decision |
| Havok:
That depends on the controls. You could squeak by with 2" depending on what controls you have, but you may want to allow 3" just in case, especially if you plan on including a Tron like joystick... |
| clickhea:
u360's happ buttons 3 inch trackball tornado 2 spinner so normally the back would be 3 inches and the front 2? |
| Navigation |
| Message Index |
| Next page |
| Previous page |