Main > Main Forum

Another T-Molding question

Pages: (1/1)

mj147:

Sorry Im sure this topic has been covered before but I was unsuccesfull in finding it  :(

I just received my t molding and after test fitting it I noticed its a hair (literally) wider, using 3/4 T molding on  3/4 birtch ply. Is this common, if so do trim off the excess? On my  sega made cab the t molding is flush with the side, but doest look like it was trimmed.

Any help/advice would be appreciated

mj147

slug54:

Is it overhang just on one side?
If so you didn't have the slot cutter centered.
If it overhangs on both sides I would tend to leave it , Unless your putting molding around your C-panel  then it might need to be trimmed.

                        Slug54

mj147:

Aye it overhangs  just a hair on both sides, just wasnt sure if this was the norm and I have to trim it or not.


mj147

IIOIOOIOO:

Pretty sure they sell a device to fix this. You clamp it on both sides, and zip it up and down the t-molded rail. Think i've seen one on T-Molding.com

Pages: (1/1)

Go to full version