Main > Main Forum
Donkey Kong/nintendo joystiq question
itobandito:
Yeah the bottom part did fall apart once I removed the e-clip I have to look at it when I get home I believe that golden part of the controller(see top pic in first post) prevents me from sliding the guard in. I cleaned the whole thing in CLR and it rust free from what can be actually seen. BTW, I bought the cleark DK guard from Mike's Arcade. Does any one know where I can get a black one?? He also sells the black WICO ones do those work? Any recomendations?
DeLuSioNal29:
Here is the schematic for the joystick.
MaximRecoil:
--- Quote from: itobandito on January 09, 2008, 04:35:49 pm ---Yeah the bottom part did fall apart once I removed the e-clip
--- End quote ---
Then just pull the joystick shaft out of the base, or tip it upside down and it will fall out, assuming it is not seized from rust.
--- Quote ---I have to look at it when I get home I believe that golden part of the controller(see top pic in first post) prevents me from sliding the guard in.
--- End quote ---
That amber plastic cylinder doesn't come off? I would think it would but I don't know for sure because none of my Nintendo joysticks have the removable balltop like yours does (they were made both ways).
Kremmit:
That clear dustwasher disk you bought is the type that came on Donkey Kong machines (others?), and was installed above the CPO.
itobandito:
--- Quote from: Kremmit on January 10, 2008, 12:02:51 am ---That clear dustwasher disk you bought is the type that came on Donkey Kong machines (others?), and was installed above the CPO.
--- End quote ---
Ok cool. I will put it there. Last night Delusional29 and I took a really close look at the stick and took a hammer to it and guesss what, the thing was indeed rusted together, even after soaking it in CLR. So I am good now, thanks for your help guys. Actually anyone know where I can get the black joystick guard that went underneath the CPO??