Main > Main Forum

QD to screw terminal adapters

Pages: (1/1)

ultrageek:

This can be moved to any better section if someone thinks it fits better elsewhere...

I am tired of the "cut and re-crimp" method of repairing problems or making changes in my CP.
So, I am looking for an adapter that may or may not exist.

It would have the .187 female QD connector (i.e. to connect to the cherry switches) on one end a screw terminal on the other to accept the wire. Ideally, it would be able to handle anything up to 16 AWG wire.

Has anyone seen anything like that?

MaximRecoil:

It is unlikely that anything like that exists. You could solder single-input terminal blocks (the type with through-hole mounting posts) directly to the tabs of your microswitches though. The tabs of microswitches already have holes so it would be easy to through-hole solder something to them.

Fozzy The Bear:

Yeah! Just use terminal blocks like these....
You can break them off the block into individual ones and run a wire with a crimp connector on the end to your switch. The other side then gives you a screw terminal.

Best Regards,
Julian (Fozzy The Bear)


Pages: (1/1)

Go to full version