| Main > Main Forum |
| Drilling, Cutting, etc PlexiGlass |
| << < (3/3) |
| amerish:
leave the paper on the plexi. Then put the plexi over your drilled top of the control panel. Turn on a flashlight and put it into the panel and you will see ever hole lit. Drill into the hole with a plunger bit on the router then switch to a flush trim bit to clean out the hole. Works perfectly every time I have done it. |
| Kajoq:
For cutting the plexi, making a sandwich with Wood | plexi | wood, and cutting slowly worked well for me. Doing the holes, drill a small pilot hole first, A spade bit SHOULD work, but I used a holesaw bit and that worked perfect. The hole cutting went much more smoothly than straight line cutting |
| Malenko:
I drilled the holes for the screws that held the plexi to the panel, then I mounted the plexi to the control panel then used a dremel to slowly cut out the holes for the buttons. messy but its all the hardware i own :/ and it worked |
| knave:
When I drilled Acrylic I used a small pilot hole and then used a slow to medium speed to drill out the hole. I used a block of wood underneath. Worked great. |
| Navigation |
| Message Index |
| Previous page |