Main > Main Forum

Drilling, Cutting, etc PlexiGlass

Pages: (1/3) > >>

kelemvor:

What's the best way to cut plexiglass to cover a CP?  I've used my table saw before and ended up with little plastic shards flying everywhere in my workshop.  Also for drilling the holes too.  Not sure if I can just drill them with my spade bit or if something else works better.

ANy advice would be great.

fixedpigs:

What's the best way to cut wood to make a CP?  I've used my table saw before and ended up with sawdust flying everywhere in my workshop.  Also for drilling the holes too.  Not sure if I can just drill them with my spade bit or if something else works better.

ANy advice would be great.

leapinlew:

Router with a flush trim bit.

leapinlew:

Starting here and work your way through a couple posts on page 2.

http://forum.arcadecontrols.com/index.php?topic=55021.msg547383#msg547383



kelemvor:

Well, 2 out of 3 replies that are actually useful.  Not too bad of a percentage I guess.

Have to go dig out the router I guess.  Pretty sure I have a flush trim bit around somewhere.  heh heh.

Thanks.

Pages: (1/3) > >>

Go to full version