| Main > Main Forum |
| Drilling, Cutting, etc PlexiGlass |
| (1/3) > >> |
| kelemvor:
What's the best way to cut plexiglass to cover a CP? I've used my table saw before and ended up with little plastic shards flying everywhere in my workshop. Also for drilling the holes too. Not sure if I can just drill them with my spade bit or if something else works better. ANy advice would be great. |
| fixedpigs:
What's the best way to cut wood to make a CP? I've used my table saw before and ended up with sawdust flying everywhere in my workshop. Also for drilling the holes too. Not sure if I can just drill them with my spade bit or if something else works better. ANy advice would be great. |
| leapinlew:
Router with a flush trim bit. |
| leapinlew:
Starting here and work your way through a couple posts on page 2. http://forum.arcadecontrols.com/index.php?topic=55021.msg547383#msg547383 |
| kelemvor:
Well, 2 out of 3 replies that are actually useful. Not too bad of a percentage I guess. Have to go dig out the router I guess. Pretty sure I have a flush trim bit around somewhere. heh heh. Thanks. |
| Navigation |
| Message Index |
| Next page |