| Main > Main Forum |
| Rethinking the 4-player control panel... |
| << < (4/6) > >> |
| vidmouse:
Delusions link to the 4p mini quad was interesting... it's actually similar to my angled design except the panel is 1.75" deeper. I tried it out w/ my drawing program and the only advantage I see over what I have is that it gets the players a little further from the screen, maybe improving viewing angle. I gave this some more thought last night and am back to the modular idea once again... I abandoned it for awhile b/c I wasn't sure how to attach the module "wings" but last night I thought about maybe just using some large bolts and wing nuts, shoot through the side of the CP boxes and use the wing nuts to hand-tighten in whenever I need the 4p capability. The downside... my pinball buttons get covered up by the wing modules but these can be taken down. Any other suggestions on how to attach/detach easily? |
| arzoo:
I've never had a problem playing with angled controls on P3/P4 - up is forward, down is backward, etc. It's all relative to the player position, not the monitor position. The reason for angling players 3 and 4 is because that's the natural position the player will take to face the screen. Unless you have a wide-screen monitor, players 3 and 4 will stand to the left and right of the screen - if they were to face forward, they wouldn't be looking directly at the screen. Anyway, my 2 cents. Vidmouse - I'd go back to your original design. |
| Sir Auros:
With that modular design, think about the 40 wire connections you'll have to make every time you want to hook those up. Try your original with a cardboard mockup and some friends and see if angled will work for you. |
| vidmouse:
1 joystick = 4 connections 6 buttons = 6 connections 1 ground, daisy chained Total 11 connections per module. The P1 and P2 modules wouldn't have to be unhooked at all. The plan was to use two 6-pin block connectors for each module. unless I'm missing something...? |
| Sir Auros:
I didn't see where you mentioned that you were going to do that. I was counting the connections for the grounds to the switches, too. |
| Navigation |
| Message Index |
| Next page |
| Previous page |