Main > Software Forum

LEDBlinky - Arcade LED Control software and Animation Editor - v8.2

<< < (418/419) > >>

midd:
Is it possible to configure buttons for games in Mame software lists? I’m trying to light up buttons for colecovision games that used the super action controllers. For colecovision, Mame requires the roms to be unzipped and in a folder. It’s my first time using software lists. So as not to screw up my main mame configuration I added a second mame just for colecovision. Not ideal for this specific situation probably.

SR230cc:
Just an update to my question.  I moved Ledblinky to the Launchbox folder and put mame in the emulators folder along with the roms.
everything works now.  Must have been something with the Launchbox update.

Note:  I used mame to generate the .xml.

Jordiculebcn:
Good day everybody

just 2 weeks ago I purchased a PACDRIVE board.

The idea was to integrate GUITAR HERO 3 and be able to blink 8 leds using the board and ledblinky.

I am using LAUNCHBOX and it seems it works. But I am not able to just blink the led when the guitar button is pushed.

Just checked forum, web, youtube videos, etc. but I can't fins any option to be able to reach it. I can have the leds on in the Game: just ON, with animation, etc. but no the way I would like: always OFF except when I push specific button

IS there any way to get it working? I am getting crazy

Thanks very much for your help

PL1:

--- Quote from: Jordiculebcn on October 08, 2025, 07:16:49 pm ---I can have the leds on in the Game: just ON, with animation, etc. but no the way I would like: always OFF except when I push specific button

IS there any way to get it working?

--- End quote ---
I'm not sure about the hardware you're using, but you might be able to wire your setup like #3 and use the ground provided by the PACDRIVE output in place of the regular ground shown in the diagram.

LED is normally off.  When you press the button, ground is applied to the encoder (triggers button press output) and also to the cathode of the LED. (lights the LED)




Scott

Jordiculebcn:
Good day Scoot,

thanks very much for Your quick reply.

I am using PACDRIVE as below connection.



not sure if, with this board, is there any other option to connect as per Your advise

thanks!

Navigation

[0] Message Index

[#] Next page

[*] Previous page