| Main > Main Forum |
| Jamma edge cconnector problems |
| (1/1) |
| g.robert:
I want to purchase from Bob Roberts a Jamma edge card connector with pins ASAP. I have a converted (from killer instinct) area 51 site 4. It frequently re-starts sometimes sticking in a continuous shut down / re-start mode. It seems when I wiggle the Jamma edge card connector the problem goes away for a few hours to days. I believe this is due to a loss of the +5VDC at that connection. Am I on the right track? |
| SirPeale:
Sounds like it. You could just tighten up the connection and clean the pins so it makes better contact. |
| g.robert:
Thanks, I'll give it a shot. |
| ArcadEd:
If the cleaning doesn't work, try putting a bead of solder on the pin on the board. This will cause the connector to go in a bit tighter and make a better connection. |
| Navigation |
| Message Index |