Main > Main Forum
Need template for over under coin door
(1/2) > >>
steveh:
I have 2 over under coin doors, and i need a template so i can cut the front of my cab.  if any one has one, or can tell me when i can find one that would be great.

i am pretty sure this is the door i have (or at least something very similar to it.

http://www.happcontrols.com/coindoors/40003800.htm

thanks in advance.
Red 5:
You could use the hole cutout diagram on the page that door is on.

http://www.happcontrols.com/coindoors/40003800_exploded.htm

Jon
steveh:
i am really looking for something i can print out and tape to it, and just cut it out that way.
Red 5:

--- Quote from: steveh on November 04, 2007, 02:38:52 pm ---i am really looking for something i can print out and tape to it, and just cut it out that way.

--- End quote ---

I will draw you one in AutoCad and post a .jpg

Ok?
Jon
Red 5:
I had to go PDF on it but if you print 1 to 1 it should work.

I left the measurements on there so you could check it.

Have Fun,
Jon



edit - I really need to learn grammer
Navigation
Message Index
Next page

Go to full version