Main > Main Forum
Oscar Spinner / Optipac board - Not working
<< < (2/2)
Dazz:
Was there ever a fix on this issue?  I haven't touched my spinner in about a year and just now getting around to re-wiring it.  I am having this same exact issue.  I am getting 5v from both the player 1 rotary and player 2 rotary.  Trackball works perfectly, but I just can't seem to get my Oscar spinner going.
Encryptor:
In order to disable the wheel. Go into Control Panel, Mouse.

Under Mouse Properties go to the Hardware tab.

Click on the Properties button near the bottom.

Under the PS/2 Compatible Mouse Properties go to Advanced Settings.

Use the pull down menu by Wheel Detection. There should be a setting to Disable Wheel Detection.

I hope this helps.

Encryptor
Dazz:

--- Quote from: Encryptor on January 27, 2008, 09:17:50 pm ---In order to disable the wheel. Go into Control Panel, Mouse.

Under Mouse Properties go to the Hardware tab.

Click on the Properties button near the bottom.

Under the PS/2 Compatible Mouse Properties go to Advanced Settings.

Use the pull down menu by Wheel Detection. There should be a setting to Disable Wheel Detection.

I hope this helps.

Encryptor

--- End quote ---
Thanks for the suggestion, but these steps don't work if you use USB devices... There are no PS/2 Compatible Mouse Properties options or Advanced Settings.  Unless the driver that Windows found for the Opti-pac are not the correct ones.  My trackball works perfectly.
Navigation
Message Index
Previous page

Go to full version