Main > Main Forum

Button Sizing and Spacing.

Pages: << < (2/3) > >>

stace:

Thanks Guys  :cheers:

Malenko:

I used a spade bit, its all I had  :dunno

NoOne=NBA=:


--- Quote from: javeryh on November 01, 2007, 02:31:26 pm ---I use forstner bits to drill out the holes and I space them 1-3/8" on center.

--- End quote ---

Ditto here.

More important than the type of bit you use is making sure that you are not drilling the hole at an angle.
I don't know how many times I've seen a "defective button" that suddenly worked when you let up some pressure on the keeper nut.

Avrus:

I used a spade bit and the point on the spade bit allows you to line up the button exactly.

ArtsNFartsNCrafts:

I purchased my push buttons from ultimarc.  Anyone know the specs on these as far as proper spacing and spade-bit size for drilling?

Thanks!

Pages: << < (2/3) > >>

Go to full version