| Main > Main Forum |
| Button Sizing and Spacing. |
| (1/3) > >> |
| stace:
Guys, I'm trying to sort out my cp design and hope you can help? I understand that a happ button requires a hole of 1 1/8" is that correct? What is the overal width of the button including the 'lip' ? Thanks Stace :) |
| 4Aaron GE:
Most buttons are spaced 1.5" apart, centre to centre. |
| csa3d:
--- Quote from: stace on November 01, 2007, 11:25:51 am ---I understand that a happ button requires a hole of 1 1/8" is that correct? --- End quote --- This is correct. I personally suggest a fostner bit. For other hole related questions, don't forget about this thread about hole sizes. -csa |
| vidmouse:
I've also used a step bit... a little rougher going, but it gave me a cleaner hole. From what I've read, most people get away with just using spade bits too. I think I saw a set of forstner bits at Big Lots the other day for $15 or so... don't know how good they are though. |
| javeryh:
I use forstner bits to drill out the holes and I space them 1-3/8" on center. |
| Navigation |
| Message Index |
| Next page |