Main > Main Forum

microswitch problems help! quick disconnects dont fit mag stick plus wire issue/

Pages: << < (2/3) > >>

knave:

To open up the .187 female connectors first use a small screwdriver to open them up a bit then use some pliers to size them.

Hope that works. 

mrclean:


--- Quote from: krutknut on October 22, 2007, 03:45:15 pm ---Don't worry, it should be extremely easy. As long as the wires are not too short for a mistake or two...

--- End quote ---

Ooops ran out of room for the existing wires to stretch with the new disconnects, so what wire do i use it's for a "daisy chain" from a button to my joystick the wire is red. maybe ground? other wire is tiny tiny tiny and grey going from i think a mini pac looks like a ribon. But I can't seem to figure out where the red wire lead comes from reguardless I need to purchase more for the short daisy chain. ended up with 18 gauge from radio shack

mrclean:

After finally finishing It's time for game testing.. I'm finding that somethings not right in terms of game play even pacman doesnt seem to be that responsive I mean within my front end up,down, left and right work on my CP.. however my joystick is not perfectly center would that be of an importance? Also underneath I have this tiny metal piece which maybe interfering with the magnet ?

kowal:



jasonbar:

If I'm understanding the problem correctly, why not just file/sand/dremel/grind the tabs so they're a little skinnier to fit into the female quick disconnects?  I've done it many times.

-Jason

Pages: << < (2/3) > >>

Go to full version