| Main > Main Forum |
| microswitch problems help! quick disconnects dont fit mag stick plus wire issue/ |
| << < (2/3) > >> |
| knave:
To open up the .187 female connectors first use a small screwdriver to open them up a bit then use some pliers to size them. Hope that works. |
| mrclean:
--- Quote from: krutknut on October 22, 2007, 03:45:15 pm ---Don't worry, it should be extremely easy. As long as the wires are not too short for a mistake or two... --- End quote --- Ooops ran out of room for the existing wires to stretch with the new disconnects, so what wire do i use it's for a "daisy chain" from a button to my joystick the wire is red. maybe ground? other wire is tiny tiny tiny and grey going from i think a mini pac looks like a ribon. But I can't seem to figure out where the red wire lead comes from reguardless I need to purchase more for the short daisy chain. ended up with 18 gauge from radio shack |
| mrclean:
After finally finishing It's time for game testing.. I'm finding that somethings not right in terms of game play even pacman doesnt seem to be that responsive I mean within my front end up,down, left and right work on my CP.. however my joystick is not perfectly center would that be of an importance? Also underneath I have this tiny metal piece which maybe interfering with the magnet ? |
| kowal:
|
| jasonbar:
If I'm understanding the problem correctly, why not just file/sand/dremel/grind the tabs so they're a little skinnier to fit into the female quick disconnects? I've done it many times. -Jason |
| Navigation |
| Message Index |
| Next page |
| Previous page |