| Main > Main Forum |
| Looking for a "Aux Output Adaptor Board" for a blitz/showtime 2000 |
| << < (2/2) |
| metahacker:
is this board located in the CP? |
| u_rebelscum:
Umm, pkurz, are there two or three of you? Or is someone else also using your login? You posts confuse me, but it could just me me. :dizzy: --- Quote from: pkurz on October 17, 2007, 07:49:14 pm ---the aux out adaptor board from what I found out is nothing more than a wire bridge board, there is nothing circuitry on this board, a 20 ribbon cable connects this to the main board, then it goes to a 15 pin connections, and only 6 of the 15 are used to go to the i-40 board. What I need to know is what wires from the ribbon cable is used, if someone has a blitz they could take a picture of this and post in on line.... Then you could really make your own. --- End quote --- Thanks for the info. I had thought it had a chip and timing crystal on it? I'd like to see how to make your own, too. --- Quote from: pkurz on October 17, 2007, 07:39:10 pm ---happ has the i-40 boards, that is where I got mine --- End quote --- Is that part number I posted the correct one? I might get one just to check it out. --- Quote from: alexdog69 on October 18, 2007, 11:58:30 am ---is this board located in the CP? --- End quote --- I don't have a cab, but in the manuals it's a small board off to the side of the main PCB. |
| Navigation |
| Message Index |
| Previous page |