Main > Project Announcements
Mike's Arcade Machine Emulator (Knievel inspired) It's Alive!
gatordad:
--- Quote from: Gangor on November 08, 2007, 03:43:10 pm ---What program did you use to make the control panel diagram? Looking good so far, keep it up!
--- End quote ---
Thanks and welcome to the boards, I used Adobe Illustrator. Lots of good help and talent around this site.
Regards
GD
gatordad:
Broke out the router and cut the slot for the t-molding on my sideart cutouts. I practiced on a piece of scrap since it wss my first time using a router
Wood glue really is pretty strong, you can see one of the dowels I used to fill the origional monitor bracket holes, it got sliced and diced and is still holding strong.
I also had time to clean some buttons that I don't need, these will find there way to the BST or ebay in a couple of days.
I got a whole bunch of cutting done yesterday, new front kickplate, coindoor cutout, speaker cutouts, two shelves and supports, cp top, and some new sides for my cp box.
More pictures tomorrow I have to get um off my camera.
gatordad:
Some pictures from last weekend, made good progress, I enlisted the help of my father in-law, he's known around these parts as Mister fix it.
Cutting the cp top
Inside of cab painted flat black just because I wanted a clean look when door is opened
monitor shelf and brackets are done, coin door is next
I cut new sides for the cp box and took off the blitz sticker after I snapped this picture.
Getting closeer.........
gatordad:
Primed all on my pieces the other day
installed the monitor support and made sure height and angle was correct
I am going to borrow a friends spray paint equipment this week end. I hope to done painting in a couple of days.
The excitement is building........can't wait till it works.
jcoleman:
--- Quote ---I am going to make some ( final?) changes tonight
--- End quote ---
Final?! Final?!?!? :laugh2: ...
Seriously, if you ever decide you are finished with your cabinet then you must have found another hobby. ;) If in doubt see the Mission Control thread!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version