| Main > Main Forum |
| Shorten tab on t-molding? |
| << < (2/2) |
| More Cowbell:
--- Quote from: bluevolume on October 16, 2007, 03:07:30 pm ---Unless you've tested this using a cross-section of MDF, you may not know that you are splitting it. --- End quote --- What I don't know can't hurt me. |
| Tahnok:
If you're really worried about it, just do two passes with the router. Offset it a little, run it on one side, flip it over and run it again. As long as you keep the offset the same and run it on both sides, you'll end up with a wider centered slot. |
| Navigation |
| Message Index |
| Previous page |