Main > Project Announcements
Building 2x bartop cabinets (Second cabinet complete!!!)
dmworking247:
--- Quote from: leapinlew on October 21, 2007, 01:43:02 pm ---Question - I was looking at your pics and it appears the one bartop doesn't have enough room for controls?
--- End quote ---
Which one? Bartop A or B from the photos above?
Bartop "A" will have control panels that slot inbetween the side panels and the T-Molding is only on the cabinet. Because the removable control panels fit between the side panels pinball buttons aren't feasible.
Bartop "B" specifically needed to have pinball buttons, which is why the side panels dont extent out with the base panel and instead the control panel will be full width. You can see the control panel for this bartop being constructed in the last photo.
leapinlew:
This one doesn't look like it's deep enough to support controls. I mean, I'm sure you've got it all figured out - I just don't see how it's all going to work just yet.
dmworking247:
Yeah it'll be a tight fit but all of the components I've considered will fit within the height of the control panel.
There is 5cm (2") clearance under the CP surface and the floor panel at its lowest point, up to 8cm (3.xx") at the back.
The only thing I might have a little trouble with is my trackball, but thats going to be routed underneath too which will give me back another 1cm (2/5").
All will be revealed in time :D
leapinlew:
I saw you ask about the USB ports in another thread. The solution I used is a bit pricey, but looks real nice.
http://www.datapro.net/products/usb-dual-horizontal-plate.html
dmworking247:
Hmm, seems that whatever is on the back of that plate (minus the plate itself) is exactly what I need.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version