Main > Main Forum

Can I add a "spinner" to my cab, and will it fit between two buttons ?

Pages: << < (3/4) > >>

Chris:


--- Quote from: mrclean on October 11, 2007, 11:10:40 pm --- I think as a test I'm going to raise my middle button up, and play a few trackball games to see how badly it really would be.
--- End quote ---
A spinner knob is a LOT more solid than a button and hurts more when you run into it.

TOK:


--- Quote from: Chris on October 11, 2007, 10:25:17 pm ---
--- Quote from: TOK on October 11, 2007, 09:53:41 pm ---I don't care for that positioning either... I put mine well off to the lower right of my panel.

--- End quote ---
It doesn't get in the way for player 2?


--- End quote ---

Not at all... With hands on the stick and buttons, the spinner is still a couple inches from any of your fingers.
I fiddled around a lot with the placement before I decided on the final position.


Chris:


--- Quote from: TOK on October 12, 2007, 01:46:31 pm ---Not at all... With hands on the stick and buttons, the spinner is still a couple inches from any of your fingers.
I fiddled around a lot with the placement before I decided on the final position.

--- End quote ---
Very nice.  I did want a spinner but could never find a place for it that wasn't in the way.

rockin_rick:


--- Quote from: mrclean on October 11, 2007, 11:10:40 pm ---So does any one know the dimensions of the TT2 Spinner? How high does it come off the panel ?

--- End quote ---

I just measured (with calipers) my TT2 with the token top knob and it is almost exactly 1" tall.

Rick

mrclean:

ok, Not to sound picky... but can you get an attachment for the TT2 that looks like the arkanoid paddle found this off arcadeshop.com : with those same grooves in the paddle ?
 

Pages: << < (3/4) > >>

Go to full version