Main > Main Forum
Questions on Book version of cabinet
<< < (2/3) > >>
BobA:
If the cabinet in the book is the original U1 here is a side view of it.  The speaker panel was very small.

Encryptor:
I believe the part about the monitor shelf being flush is corrected somewhere in errata section on the book website. www.projectarcade.com

Also the speaker mounting instruction are on page 45 in the book. It then shows a pic on page 46.


Encryptor.
Xam:

--- Quote from: GAtekwriter on October 08, 2007, 09:55:10 am ---Xam,

Did you pull the monitor shelf all the way to the front, flush with the front edges of the cab's sides OR did you recess it 3/4" inch?

Jim



--- End quote ---
Mine is flush.
Avrus:

--- Quote from: GAtekwriter on October 06, 2007, 06:41:57 pm ---I'm a little stumped (mainly tired) on some issues that I hope some of you might be able to help me with -

1.  I've mounted the speaker shelf but I cannot seem to find where the book specifies where the front edge of the speaker shelf should rest... how far back?  It's angled, so does the upper corner have to touch the 3/4" inch standard inset or the bottom edge?  I know this is important because it'll affect the marquee placement.

Thanks!  Pic below of the cab's current status.

Jim

--- End quote ---

It actually talks about this on page 2 hundred and whatever.  The speaker shelf (and the top) are both recessed 5/8" or so to make room for the marquee.
GAtekwriter:
Page 200 and whatever... okay, that narrows it down ;)

I'm sure it's in there somewhere... I'm just a bit brain dead right now.  And now you say 5/8" and not 3/4" - so I better go read the book again.

Jim

Navigation
Message Index
Next page
Previous page

Go to full version