Main > Main Forum

Donkey Kong Upgrading Problem

Pages: << < (3/3)

markrvp:


--- Quote from: Burner88 on October 08, 2007, 06:33:31 pm ---I am going to replace the wiring harness from the JAMMA adapter with a full wiring harness from Mikes Arcade (www.mikesarcade.com). This will also require re-wiring the control panel and the coin box. Is there a relatively easy way to determine if the pcb is okay? It was working before this project started and I hope I have not done something stupid.

Markrvp, any suggestions?

Thanks,

-David

--- End quote ---

Did you ever check to see if you were getting the proper voltage out of the switching power supply?  If so, is it getting to the board through the Jamma harness?

Pages: << < (3/3)

Go to full version