| Main > Main Forum |
| Finger guard for 200mm fan? |
| (1/1) |
| Avrus:
Anyone have a suggestion of where to find or even how one would make a finger guard for a 200mm fan? I could leave it without the finger guard but it's just going to look unpolished to have a 3/4" gap from the outside to the fan. Found some 180's or 254's I guess I could just use the 254's ... |
| SavannahLion:
Depends on how fancy you want to get. At 200mm, I would go with a mesh like this example. They're reasonably priced for the sheets that need to be formed. I forget what that specific perforated metal is called though. |
| BobA:
Was going to say your size is a bit hard to match so you probably need to fabricate your own from metal mesh available at case moding places. The honeycomb mesh is the best for airflow. http://www.mnpctech.com/moddersmesh.html |
| Ken Layton:
Just go to the hardware store and get a small piece of "hardware cloth". It comes in different sizes of the squares and you cut it with tip snips. |
| Navigation |
| Message Index |