Main > Main Forum
How do I hook up aTron spinner to an Optipac?
Paul Olson:
Thanks for the info everyone.
Clu - Do you still have the instructions for the hack? I will try to contact gl.tter, but his site looks like he may have moved on from the arcade stuff.
Thanks,
Paul
Hoopz:
--- Quote from: pcolson on September 11, 2007, 06:54:08 pm ---Thanks for the info everyone.
Clu - Do you still have the instructions for the hack? I will try to contact gl.tter, but his site looks like he may have moved on from the arcade stuff.
Thanks,
Paul
--- End quote ---
He's writing the code for the light stuff for mame. I'd bet he would email you back if you asked for it. I'll go through a box o' stuff to see if I have it still. I know I printed it when I was trying to get it to work.
Clu:
Here's the link to the original instructions - http://gl.tter.org/spinnerhack/ and I posted a couple pics of my hack here - http://www.fortunecity.com/rainbow/snowwhite/311/arcade/
I used a drill press and tiny bit to severe the traces instead of trying to cut them, and also soldered onto the traces as opposed to the led/pickups. Seemed to have a bit more room that way. I also just soldered the wires onto a 4 pin connector for easier hook-up to a standard harness instead of trying to mount it as gl.tter did. Good luck if you try it. ;)
Hoopz:
--- Quote from: Clu on September 11, 2007, 09:23:16 pm ---Here's the link to the original instructions - http://gl.tter.org/spinnerhack/ and I posted a couple pics of my hack here - http://www.fortunecity.com/rainbow/snowwhite/311/arcade/
I used a drill press and tiny bit to severe the traces instead of trying to cut them, and also soldered onto the traces as opposed to the led/pickups. Seemed to have a bit more room that way. I also just soldered the wires onto a 4 pin connector for easier hook-up to a standard harness instead of trying to mount it as gl.tter did. Good luck if you try it. ;)
--- End quote ---
Nice job posting this! :applaud:
I should have tried your way. I don't know if my board was bad to start with or if I messed it up. Just wasn't good enough to get it done.
Paul Olson:
Thanks for posting the links! Hopefully I will have time to try this sometime this week. I'll post with results after I try it.
Thanks,
Paul