Main > Main Forum
1st install of Happ Supers - not 'clicking'??
pboreham:
Hi,
I've started putting my CP together today (1st one I've done as you'll know if you've been following!) and have a quick question.
I've mouting 2 Happ Super Joysticks (8 ways obviously), but when I move the sticks, the microswitches dont 'click'. When I flip the CP over and move the metal strips to the switches, then switch goes down and it 'clicks'.
This happens in all directions - when I watch it from the back, the metal is touching the red switch, but I dont think it pushes it in far enough. Will this still work, or does the click signify 'on' (god what a stupid question!!!!)
I'm using 3/4 MDF with a Lexan top - so using the long shaft provided.
Thanks for any help, this is probably such a basic newbie question!!!! :banghead:
Thanks, Paul
ahofle:
What size holes did you drill? Is the shaft hitting the sides of the hole when you wiggle the joystick? ( :laugh2: )
Joystick Jerk:
This may be a silly question, but did you install them properly with all the parts provided? The switches won't click unless all parts are in the right spots.
xmenxmen:
xmenxmen:
--- Quote from: pboreham on August 31, 2007, 04:56:28 pm ---
This happens in all directions - when I watch it from the back, the metal is touching the red switch, but I dont think it pushes it in far enough. Will this still work, or does the click signify 'on' (god what a stupid question!!!!) :banghead:
--- End quote ---