Main > Main Forum
can the laminated cpo adhesive from mamemarquees be applied to curved surface?
ARTIFACT:
the wiki doesn't answer my specific question which was about the mamemarquees adhesive backing ... Are there things I need to watch for when peeling it, should I peel small amounts while applying it, or not, etc.
I can use common sense of course, but I prefer to be paranoid and be prepared!
:)
leapinlew:
--- Quote from: ARTIFACT on August 28, 2007, 02:15:51 pm ---the wiki doesn't answer my specific question which was about the mamemarquees adhesive backing ... Are there things I need to watch for when peeling it, should I peel small amounts while applying it, or not, etc.
I can use common sense of course, but I prefer to be paranoid and be prepared!
:)
--- End quote ---
Unless your a klingon, or your fingers are covered with super glue - the backing comes off very easily. Like wax paper.
shardian:
--- Quote from: ARTIFACT on August 28, 2007, 02:15:51 pm ---the wiki doesn't answer my specific question which was about the mamemarquees adhesive backing ... Are there things I need to watch for when peeling it, should I peel small amounts while applying it, or not, etc.
I can use common sense of course, but I prefer to be paranoid and be prepared!
:)
--- End quote ---
Yeah, I totally didn't get what you were asking. The backing comes right off. That would kind of defeat the purpose if it was stuck to the adhesive. ;)
ARTIFACT:
OK :)
I just wanted to see if there was any tips on applying it after peeling the backing... to avoid air bubbles, or anything else I am not realizing may happen
leapinlew:
What I do is pray a lot. So far it's been working really well. I'm only half kidding...
I lift up one edge and apply it to a line I've drawn that I know is straight. Then I slowly lift the backing and apply it as I lift the backing - smoothing it out for air bubbles or anything.