| Main > Main Forum |
| got U360 + long shafts ... confused ** SOLVED (missing a part)** |
| (1/3) > >> |
| ARTIFACT:
**** UPDATE - SOLVED (mising a pastic sleeve piece) **** I am swapping the short shafts with the longer ones, but I am a bit puzzled the longer shafts seem to be longer "on the wrong side" ... by this I mean that instead of the "top" being longer, it's the under/inside part that is longer. This means that (again, it "seems") the magnet is hitting the PCB instead of "levitate" above it... What is this about? YES I am reading this page carefully: http://www.ultimarc.com/ultrastik_inst.html |
| ARTIFACT:
phone pic to illustrate ... see how the loger shaft is longer under the CP, not above (it seems to me) See where the lip/bump is positioned on the shaft. Do I need to slide an additional round sleeve piece to pull the shaft up? right now there is so much space below, the spring doesn't get loaded at all -until I assemble it back with the PCB (where it gets "squished") (thx in advance) |
| mlalena:
I've also been looking at the U360, and from what I remember reading the longer shafts are for 3/4" MDF while the shorter shafts are for sheet metal control panels. So it makes sense that it is longer under the control panel. I think. |
| ARTIFACT:
I know they are for 3/4",that's what my CP is made with (plywood in my case, Birch). This is why I bought them :) but even then. By "longer under the CP" I mean longer INSIDE THE JOYSTICK if that makes more sense look at the pics. Instead of the stick being longer outside the U360, it's the part under the lip (thinner part of the shaft) that is longer. |
| javeryh:
I am using the long shaft in my U360 and I don't recall there being any type of issue swapping it out. Just be sure to keep everything in order (the clip, spring, etc.) and everything should line up. |
| Navigation |
| Message Index |
| Next page |