Main > Project Announcements
O'Boyle's Arcade - by the "book"
leapinlew:
:applaud:
Lookin good bud!
javeryh:
Wow - awesome job so far! :cheers:
Spyridon:
Today I was able to cut out the holes for the speakers. I wasn't sure what speakers I was going to use until yesterday when I picked up a set of Klipsch 2.1 speakers on eBay. Since these were the same ones used in the book, I was able to use the provided templates.
Spyridon:
I was also able to get the control panel cut out of the 5/8" MDF. I used the one I had cut out previously in the 3/4" MDF as a template. Once cut out, I used the router to cut out the slot for the t-molding. The slot is not in the center, but that is because this will have a piece of 1/8" plexiglass over it.
Donkey_Kong:
--- Quote from: Spyridon on August 17, 2007, 10:28:52 pm ---Now it's time for cutting. Having never really used any power tools, I did what everyone in this forum does...bought myself a whole new set up tools
--- End quote ---
Wow, I'm very impressed especially because of the fact that you never really used power tools prior to this project. Looking at the results so far, that would be very hard to guess.
Good luck on the rest of the project.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version