Arcade Collecting > Restorations & repair
Asteroids Restoration -- Hardware 100% / Starting Cab work...
Kaytrim:
Maybe you are dealing with a botched up conversion in progress. The seller couldn't make the phoenix board work so just sold it off to recoup some cash. You might want to do one of two things. Get a real Astorids boardset (if you can find one) or swap the monitor and other high voltage stuff and see about getting that pheonix board working.
TTFN
BobA:
Either go for an asteroids board for your monitor or get the phoenix board going on a regular arcade monitor. Even a small add on board is not going to convert a raster game to vector, the requirements are totally different.
mcfreak:
--- Quote from: BobA on August 15, 2007, 08:39:25 pm ---Either go for an asteroids board for your monitor or get the phoenix board going on a regular arcade monitor. Even a small add on board is not going to convert a raster game to vector, the requirements are totally different.
--- End quote ---
Done, have a working one on the way, however, that takes some of the fun out of this. At least I will get to test my monitor...
CheffoJeffo:
--- Quote from: mcfreak on August 15, 2007, 09:04:03 pm ---Done, have a working one on the way, however, that takes some of the fun out of this. At least I will get to test my monitor...
--- End quote ---
Careful what you wish for ... ;)
mcfreak:
So I started sanding the sides down where it was cut... (damn that was painful watching the side art paint disappear in that section). Once I bondo that up and sand again I am going to need new sideart. I know I can get the sideart overlay for 135 at arcadeshop but my question is:
Do they have a Stencil set for the Asteroids sides that you can paint the 4/5 colors back on?
BTW, new PCB should be here tomorrow...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version