| Main > Main Forum |
| My CP Layout, Spinner + drill/router bits questions |
| << < (2/5) > >> |
| javeryh:
I'm not sure why any supports are needed since it looks like he drilled in from the sides. I would get rid of them completely. As for the "exit" button, I'd relocate it to the far top left or top right corner - as far away as possible from any other button/control. This is a pic of my CP: The exit button is the lone button on the far left and the 3 on the right are P1 start, P2 start and pause. Just a thought. :cheers: |
| ARTIFACT:
--- Quote from: javeryh on August 08, 2007, 05:28:02 pm ---I'm not sure why any supports are needed since it looks like he drilled in from the sides. I would get rid of them completely. --- End quote --- well i dont want to screw to the plywood side - it slits easily - so the mounts decouple and make a much stronger cp top. i dont trust screws on plywood edge. in any case i may have enough width and i can always cut the supportsin half down to 3/4 '' if anything thanks about exit btn idea - i think ill do that. amyone could give me measurements for the tornado spinner *box* under the shaft? |
| ARTIFACT:
--- Quote from: xmenxmen on August 08, 2007, 05:22:20 pm ---Another suggestion getting more space, have you consider 1x3 support instead of the 2x2. If you use latches and have support on all 4 side, I don't see a problem with that. There's also the possibility of putting support on the 4 corner and freeing up the middle giving you all 28in to work with like my poor attempt as attached. Forgot to mention the white section is the 4 corner support. --- End quote --- omg thank you! so simple yet i didnt think of it :-) i really appreciate it guys... what a great community! ill work on an update tonight. |
| ARTIFACT:
. Updated CP layout, incorporating feedback - see exit/menu button away in the left corner, and rotated joysticks to save space - keeping the 2x2 mounts, I don't need to be THAT close from the edge Hidden Lines: CLICK HERE FOR LARGE VERSION X-Ray: CLICK HERE FOR LARGE VERSION Perspective view (ignore the innacurate stick tops :) ) CLICK HERE FOR LARGE VERSION I *really* need the dimensions for the Tornado Spinner ... I am worried that the guts of it under the CP are too large to fit where I want it. Any owner of htat spinner around? Mind measuring it or attaching a PDF spec of it? THANKS THANKS AGAIN for the great input. |
| javeryh:
I'm reasonably certain that the footprint is 2" square but I'm not sure on the depth. It's more than 2" though I think. Why not go with the TurboTwist2 spinner from GGG? http://groovygamegear.com/webstore/index.php?main_page=product_info&cPath=86&products_id=268 It's the same size as a pushbutton. |
| Navigation |
| Message Index |
| Next page |
| Previous page |