| Main > Main Forum |
| My CP Layout, Spinner + drill/router bits questions |
| << < (4/5) > >> |
| ARTIFACT:
QUICK QUESTION: Is 1 1/8 hole saw a standard size? My neighbor has 2 cases with different hole saw kits - he lent me a 3" one for the trackball, but didn't have 1 1/8" ... the closest was 1 1/4" I'm going to call around to see |
| javeryh:
It's a very common size - look for a foerstner bit or a spade bit (it's a little small for a hole saw but I've seen them). |
| ARTIFACT:
got it from the store! thanks |
| ARTIFACT:
i built a mockup of my CP on a scrap board :) i will post pics in my project thread - lets take this there from here. thanks everyone for your support and help! |
| ARTIFACT:
Continuation of the CP of my cab project is here: http://forum.arcadecontrols.com/index.php?topic=68794.0 (thanks again everyone) MOCKUP BUILT THANKS TO THE HELP HERE: |
| Navigation |
| Message Index |
| Next page |
| Previous page |