| Main > Main Forum |
| Sentinel (Again) |
| (1/1) |
| Normski-MRN:
I want to wire (a fully working) Sentinel 30/35 box into my winipac switch. No before doing this I want to check I have go it working off +12v and ground the Parallel Interface shows: Pin 1 - COM A Pin 2 - A.1 Pin 3 - NC Pin 4 - A.2 Pin 5 - A.3 Pin 6 - Select Pin 7 - A.4 Pin 8 - I.4 Pin 9 - 12v Pin 10 - 0V Pin 11 - I.3 Pin 12 - I.2 Pin 13 - I.1 Pin 14 I.5,6 Pin 14 I.7,8 Now I have wired Pin 9 to 12v and Pin 10 to 0v (GND) and Pin 1 to 12v If I do this all coins reject. If I disconnect Pin 1, the first coin accepts and further coins are rejected. Question: How do I wire Pin 1 |
| lanman31337:
I think that would go to the ground (or common) on your ipac. |
| Navigation |
| Message Index |