| Main > Software Forum |
| Mame Hooker 2.0 Released! |
| << < (2/5) > >> |
| brock.sampson:
So I made a very simple jpg file 800x600 single color with some text in the middle. Same results loads fine the first time only partially the second. Also as I noted in my original post I'm able to recreate this problem without using mame just using the test command within mamehooker. I also tried adding a wat 1000 before the lds command, same results. Below are the entire contents of the dis file which doesn't seem to be very large to me. gt2k.dis [Layout] x=0 y=-768 width=800 height=600 image=gt2k.jpg I set the resolution all the way down to 640x480 on my secondary monitor, made a 640x480 image, and I still get a partial image on second and subsequent loads. I did find one thing interesting if I make my secondary monitor primary it will display the correct image everytime. Its only when I try to push the image to the secondary monitor it cuts it off. Let me know if you want me to try anything else. Thanks, |
| Popcorrin:
I was using mamehooker to light some keyboard leds on mamestart and it works great if you only want to light one of them. I tried to light two of them but it would only light the first one in the script. I followed the instructions in the readme for multiple commands and I could not get it to work. Here is what I had. MameStart=kbd 1 1, kbd 2 1 The directions seemed pretty straight forward so I didn't think I missed anything. Also, I was wondering if the recent changes in mame would mess mamehooker up at all, Multiple keyboards? Thanks |
| Howard_Casto:
You've got a syntax error.. It should be: kbd 1 1,kbd 2 1 Note the lack of a space..... I'll put a bit of error handling in the next build to make it a little more user-friendly. |
| Popcorrin:
That did the trick. Thanks |
| Howard_Casto:
Just for the record, mame's input changes never effect mamehooker. Only output changes do. :) New release is in the pipe, sit tight! |
| Navigation |
| Message Index |
| Next page |
| Previous page |