Main > Main Forum

Coin Door Help - AKA - I'm dumb

Pages: << < (2/2)

iamnaeth:

That's where I thought that it should go however, the mech is completely flush with the door.  It can't get under those screws.  Is the mech just too wide?

SirPeale:

Just flex the bracket a bit.  It'll fit.

Disturbed013:

Been following this with curiosity.

Any update?  Did you figure it out?  If you want I can post some pics of one of my doors.  Also, might be a good idea to post the measurements of those mechs just to make sure.  It does appear that they should fit, but maybe something is off a bit.  Do you happen to know which happs door it is?

The other thread has really good info to mod them to accept all coins, just a matter of getting them to fit.

iamnaeth:

I'll let you know this evening.  I'm heading over to my dad's workshop to continue work on the arcade today.  I'll have to look into flexing the brackets but I still don't think there is enough room.  If I recall, they'd need to bend ~1/8" which seems like a lot to me.  I'll measure the mech to see if it the typical width.  As for moding it to accept all coins, that was already done when I bought them.  Coins just slide right through, I need to make sure the microswitch will trigger though.

Pages: << < (2/2)

Go to full version