| Main > Main Forum |
| Coin Door Help - AKA - I'm dumb |
| << < (2/2) |
| iamnaeth:
That's where I thought that it should go however, the mech is completely flush with the door. It can't get under those screws. Is the mech just too wide? |
| SirPeale:
Just flex the bracket a bit. It'll fit. |
| Disturbed013:
Been following this with curiosity. Any update? Did you figure it out? If you want I can post some pics of one of my doors. Also, might be a good idea to post the measurements of those mechs just to make sure. It does appear that they should fit, but maybe something is off a bit. Do you happen to know which happs door it is? The other thread has really good info to mod them to accept all coins, just a matter of getting them to fit. |
| iamnaeth:
I'll let you know this evening. I'm heading over to my dad's workshop to continue work on the arcade today. I'll have to look into flexing the brackets but I still don't think there is enough room. If I recall, they'd need to bend ~1/8" which seems like a lot to me. I'll measure the mech to see if it the typical width. As for moding it to accept all coins, that was already done when I bought them. Coins just slide right through, I need to make sure the microswitch will trigger though. |
| Navigation |
| Message Index |
| Previous page |