Main > Main Forum
Best way to laminate the coin door panel?
pie taster:
--- Quote from: leapinlew on July 24, 2007, 07:13:15 pm ---
you don't have a hole in the panel now? How about laminate it first, and then cut the hole out of the panel and laminate at the same time?
--- End quote ---
I don't have a hole in the panel now.. but to shardian's point.. do i run a bigger risk of tearing the laminate?
Wade:
I've done a lot of laminating, and you want to do it the way shardian describes. Cutting the wood after lamination risks breaking the laminate as well as pulling it off from the blade movement.
Wade
bfauska:
I agree with Wade and Sheridan. Hole in panel, laminate, Drill hole in laminate for flush trim bit (a few inches inside the part about to be removed), flush trim.
pie taster:
Thanks for tips guys.
Very helpful!