Main > Main Forum
Is it OK to top-mount Mag Stick PLUS joysticks? (flush, inset plate)
ARTIFACT:
my CP is 3/4" (~19mm)
Isn't there enough space between the mountplate and the connectors? (attaching a picture)
Especially if I use the router to cut an inset at the top to flush the mountplate?
I guess I just need ot wait for the control parts to arrive, and assess ... IF Divemaster replies and has time to switch my balltops to the longer length model then I can mount under and it'll be ok I think. My bad for not planning this with more attention.
We'll see!
thanks
BobA:
You could top mount the plate by routing the area underneath to clear your connectors . You would be routing on top for the plate and underneath to clear the connectors.
ARTIFACT:
--- Quote from: BobA on July 23, 2007, 09:39:45 am ---You could top mount the plate by routing the area underneath to clear your connectors . You would be routing on top for the plate and underneath to clear the connectors.
--- End quote ---
Perfect!
I'll do that then.
Thank you very much.
AndyWarne:
There is no need to do anything special, just remove the faceplate from the joystick (4 screws) , cut the correct size hole in the panel, recess the faceplate into the top and mount it, then screw back the body of the stick onto the faceplate.
Andy
ARTIFACT:
OK then! perfect... thank you very much.
I love the BYOAC community.