| Main > Main Forum |
| Is it OK to top-mount Mag Stick PLUS joysticks? (flush, inset plate) |
| << < (2/3) > >> |
| ARTIFACT:
my CP is 3/4" (~19mm) Isn't there enough space between the mountplate and the connectors? (attaching a picture) Especially if I use the router to cut an inset at the top to flush the mountplate? I guess I just need ot wait for the control parts to arrive, and assess ... IF Divemaster replies and has time to switch my balltops to the longer length model then I can mount under and it'll be ok I think. My bad for not planning this with more attention. We'll see! thanks |
| BobA:
You could top mount the plate by routing the area underneath to clear your connectors . You would be routing on top for the plate and underneath to clear the connectors. |
| ARTIFACT:
--- Quote from: BobA on July 23, 2007, 09:39:45 am ---You could top mount the plate by routing the area underneath to clear your connectors . You would be routing on top for the plate and underneath to clear the connectors. --- End quote --- Perfect! I'll do that then. Thank you very much. |
| AndyWarne:
There is no need to do anything special, just remove the faceplate from the joystick (4 screws) , cut the correct size hole in the panel, recess the faceplate into the top and mount it, then screw back the body of the stick onto the faceplate. Andy |
| ARTIFACT:
OK then! perfect... thank you very much. I love the BYOAC community. |
| Navigation |
| Message Index |
| Next page |
| Previous page |