| Main > Main Forum |
| Is it OK to top-mount Mag Stick PLUS joysticks? (flush, inset plate) |
| << < (3/3) |
| Jimbo:
I recently bought 2 of the Mag Stick Plus joysticks from Ultimarc, and I plan on mounting them this way too. Seems easy enough but I think I'll need to remove the joystick shaft if I want to put the dust washer on top of the CP... just have to remember how to assemble it again! Jimbo |
| dternes:
I am in the process of cuttnig out my control panel and am using the magstick plus stick. I had planned on top mounting and have actually already cutout an area large enough for the middle section of the stick to fit iun from the bottom. I had planned to use the top mounting plate to sandwich the 3/4" mdf cp. My concern looking at it now is that even though the mounting plate for the stick will set flush wth the top, the screws, holes, and plate edges will be visible indentions through my cp graphics. Any ideas? |
| Navigation |
| Message Index |
| Previous page |